Market Intelligence / Data Analysis

Freehold vs Leasehold Industrial Property: Does Tenure Add Value? (2026)

Jasper Wu

Freehold vs leasehold is one of the first questions buyers of industrial property in Malaysia ask, and the raw data gives a surprising answer. Across the industrial deals in our data, leasehold property shows a higher median price per square foot than freehold: about RM556 against RM518. If freehold is supposed to be worth more, why does the raw data say the opposite?

Because the raw numbers compare the wrong things. Compare like with like and freehold’s premium comes back: about RM52,000 on a typical deal. This article shows where the gap comes from, using 23,808 transacted deals in Kuala Lumpur and Selangor from April 2021 to September 2025.

Freehold and leasehold, in brief

A freehold title has no end date. A leasehold title runs for a fixed term, after which the land goes back to the state unless the lease is extended. Under section 76 of the National Land Code 1965, state land is alienated either in perpetuity or for a term of up to 99 years, so Malaysian industrial titles come in both forms.

For a leasehold factory, the number that matters most is how many years are left. This article compares the two tenures on price; the section on lease years further down covers what the averages cannot.


The raw numbers

Raw median built-up price per sq ft: leasehold about RM556, freehold about RM518. 5,621 KL and Selangor industrial deals with recorded tenure, April 2021 to September 2025.
Raw median built-up price per sq ft: leasehold about RM556, freehold about RM518. 5,621 KL and Selangor industrial deals with recorded tenure, April 2021 to September 2025.
TenureMedian price per sq ft (built-up)Median priceDeals
Leasehold~RM556RM1.80m2,231
Freehold~RM518RM1.68m3,390

Taken at face value, leasehold is worth more per foot. That reading is wrong. It is a mix effect, not a price effect: the two groups of deals sit in very different places.


Why leasehold looks dearer: it sits closer to KL

Tenure is not spread evenly across the Klang Valley. The median leasehold deal in our data sits about 16 km from KL city centre; the median freehold deal sits about 27 km out. More than half of all leasehold deals are in Petaling and Kuala Lumpur, among the dearest districts per square foot.

DistrictLeasehold share of dealsDeals with recorded tenure
Kuala Lumpur76%296
Petaling66%1,569
Sepang59%213
Kuala Langat34%182
Hulu Langat32%911
Gombak30%617
Klang19%1,068
Hulu Selangor4%672

Districts with at least 100 deals with a recorded tenure. Freehold stock is spread further out: Klang, Hulu Langat and Hulu Selangor hold more than 60% of the freehold deals, and Hulu Selangor alone adds 645 freehold deals at a median of about RM114 per sq ft. That cheap fringe stock pulls the freehold median down.

So the raw comparison is really cheap-location freehold against expensive-location leasehold. Location, the factor that moves price per square foot the most (see the price map by district), does the work, and tenure takes the credit.


Same district, freehold costs more

Compare the two tenures inside the same district and the picture flips. In six of the seven districts with at least 30 deals of each tenure, freehold has the higher median price per square foot. Kuala Lumpur is the exception, and there the two are almost level.

Median built-up price per sq ft by tenure, in districts with at least 30 deals of each tenure. Freehold is higher in Sepang, Petaling, Gombak, Hulu Langat, Klang and Kuala Langat; Kuala Lumpur is almost level.
Median built-up price per sq ft by tenure, in districts with at least 30 deals of each tenure. Freehold is higher in Sepang, Petaling, Gombak, Hulu Langat, Klang and Kuala Langat; Kuala Lumpur is almost level.
DistrictFreehold (median RM per sq ft)Leasehold (median RM per sq ft)
Sepang~RM734~RM615
Petaling~RM709~RM576
Gombak~RM680~RM616
Kuala Lumpur~RM650~RM661
Hulu Langat~RM568~RM500
Klang~RM493~RM280
Kuala Langat~RM399~RM240

District medians still mix factory types, sizes and neighbourhoods, so treat these gaps as the direction of the effect, not its size. To measure the size, you have to hold everything else constant at once.


Like for like: about RM52,000

Our valuation model does that. It holds size, location, factory type and the other factors constant and isolates tenure (how the model works). With everything else equal, freehold adds roughly RM52,000 to a typical Klang Valley industrial deal.

That makes tenure the 7th-largest price factor in the model, and the largest one that is not about size or location. It is small next to land area, which moves a typical deal by about RM360,000 (see land value by district), but it is consistent, and it is easy to give away in a negotiation.

ViewWhat it saysWhy
Raw median price per sq ftLeasehold higher, by about RM38 per sq ftLeasehold deals sit in pricier, central districts
Same districtFreehold higher in 6 of 7 districtsLocation partly held constant
Like for like (model)Freehold worth about RM52,000 moreSize, location, type and timing held constant

Lease years left: the number to check

The RM52,000 is an average across leasehold titles of every age. A lease with 80 years left and one with 20 years left are very different assets, and the transaction data we use records only whether a title is freehold or leasehold, not the years remaining. So check two things on any leasehold you are pricing:

  • Financing: banks look at how many years will be left on the lease when the loan ends. A 2026 legal guide puts a common threshold at about 60 years left at that point; below it, banks may shorten the loan, lend less or decline (Global Law Experts). Ask your bank before you make an offer.
  • Extension: near the end of a lease, the owner can apply to the state land office to extend it, and the state charges a premium. Get an estimate of that premium before you count on an extension.

What it means in practice

  • Buying: do not let a leasehold listing in a prime estate convince you that tenure is worth more. You are paying for the location. On two comparable properties, prefer freehold and price the difference into your offer.
  • Selling freehold: tenure is a real selling point, but it persuades best against a comparable leasehold property. Lead with it where the rest of the package matches.
  • Check the lease details: years remaining, renewal terms and any consent conditions on the title swing individual leasehold deals more than the average premium does. Read the title before you compare prices.

A caveat on the RM52,000: it is the model’s average effect across the dataset. Any single deal turns on lease tenor, renewal terms and location, so treat it as a typical size, not a fixed adjustment.


Frequently asked questions

Is freehold industrial property worth more than leasehold?

Like for like, yes: about RM52,000 more on a typical Klang Valley deal, the 7th-largest price factor in our analysis. The raw median price per sq ft is higher for leasehold (about RM556 against RM518), but only because leasehold deals cluster in pricier, central districts.

Why does leasehold show a higher price per square foot in the data?

Location. The median leasehold deal sits about 16 km from KL city centre and the median freehold deal about 27 km out. Within the same district, freehold has the higher median price per sq ft in six of the seven districts we could compare.

Should I avoid leasehold industrial property?

Not necessarily. A well-located leasehold factory can be worth more than a freehold one on the fringe. On two otherwise comparable properties, though, freehold carries a measurable premium, so check the lease tenor and renewal terms before you compare prices.

What happens when an industrial lease expires?

The land returns to the state unless the lease is extended. Owners can apply to the state land office for an extension, which comes with a premium set by the state. Because banks also look at the years left, check the title early if you are buying a leasehold factory.


How we measured this

These figures come from 23,808 transacted commercial and industrial deals across KL and Selangor (April 2021 to September 2025), from NAPIC’s Open Transaction Data. The tenure comparison uses the 5,621 industrial deals with a recorded freehold or leasehold title. Prices are transacted prices, not asking prices, and price per square foot uses built-up area where it is recorded. The like-for-like premium comes from our valuation model.


About the authors

This series is by Jay Kew (REN57969, CID Realtors), an industrial property agent who brokers factory, warehouse and land deals across KL and Selangor, and Jasper Wu, the data scientist who builds the valuation models behind it. Connect with Jasper on LinkedIn.

Disclosure: Jay is a practising agent with a commercial interest in this market. Every figure here comes from transacted-price data and a documented method.

More in this series:

Related Articles